New to me 80

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Oh and Ty :flipoff2:
 
It's official:



ForumRunner_20130617_180110.webp

ForumRunner_20130617_180110.webp
 
Serious base!



ForumRunner_20130626_074147.webp

ForumRunner_20130626_074147.webp
 
It's the heart of Rock-n-Roll....! :clap: A true "Boom Box"..!:D
 
Lol, that was a random cardboard box and the amp is bunjie corded to seat mount...oh and a Walmart door speaker.
 
Install complete, now just some trimming to put the trim panel back in place.


ForumRunner_20130626_194231.webp

ForumRunner_20130626_194231.webp
 
For quite some time I've had my CB radio mounted in the dash and my HAM antenna mounted in the rear hatch. Today I built the antenna bracket for CB and mounted my HAM station.



ForumRunner_20130716_205818.webp



ForumRunner_20130716_205827.webp



ForumRunner_20130716_205838.webp



ForumRunner_20130716_205847.webp



ForumRunner_20130716_205855.webp

ForumRunner_20130716_205818.webp


ForumRunner_20130716_205827.webp


ForumRunner_20130716_205838.webp


ForumRunner_20130716_205847.webp


ForumRunner_20130716_205855.webp
 
I still need to mount the external speaker but it's all wired and ready, just need to fan that bracket.


ForumRunner_20130716_210010.webp

ForumRunner_20130716_210010.webp
 
Damn looking at that picture I think I need to pull that CB antenna mount and either radius that bottom corner or just cut the material off from bottom of gusset to bottom of door bracket...
 
Damn looking at that picture I think I need to pull that CB antenna mount and either radius that bottom corner or just cut the material off from bottom of gusset to bottom of door bracket...

:lol: Wasn't going to say nuttin until it took me out. :hillbilly:
 
I wish you would have said that before we mounted it, not sure how many more times I can tighten that insulator. And thank you again for fixing the end of that coax, it would have been messy if I'd done it.
 
Don't hate Ty! Besides way less cost in a little 3/8 material...
 

Users who are viewing this thread

Back
Top Bottom