I'm removing tons of over done bondo from my new rig and need to see what the area where the inner fender is welded to the quarter panel looks like, as well as the corner channel (rear sill) seams. Also, are the original spot weld marks visible in an untouched 40?
Off topic... any clue what the little sliding tabs are above the dome light and opposite side on the inside of the roof gutter are? And how the heck are you supposed to take the wire that runs from the windshield to the dome light out without taking the dome light apart?
Off topic... any clue what the little sliding tabs are above the dome light and opposite side on the inside of the roof gutter are? And how the heck are you supposed to take the wire that runs from the windshield to the dome light out without taking the dome light apart?