Need a little help here LV owners, please??? (1 Viewer)

[buckroseau]

Need a bit of help if a few lv owners could chime in here, need some measurements?

There is a cut out in the rear sill in the area I have circled. The area is supposed to have a switch that is fastened for the license plate lights I believe?

I think it's rectangular shaped with 2 holes on each side? My question is, distance from those inner hinge holes to each side of the rectangular hole? Size of the rectangular hole? Size of the 2 holes and distance from the rectangular hole on each side of it? PICS!! And lots of them

Thanks, Matt

 

[cruiserdan]

You tossed the old sill, didn't you.;p


Yer not 'posed to do that til yer done.....


I am no help at all but I just can't stop myself.




this smart-assed comment from the guy who tossed his Challenger quarter before he measured something on it.....

 

[buckroseau]

You tossed the old sill, didn't you.;p


Yer not 'posed to do that til yer done.....


I am no help at all but I just can't stop myself.




this smart-assed comment from the guy who tossed his Challenger quarter before he measured something on it.....

Actually I don't believe I did.........I think it's just buried out in the snow and I don't want to go dig for it ;p

Matt

 

[foxfab]

Large hole is centered on the center rib of the floor.

Center hole is 9/16"
Smaller holes are big enough for the screws to go through.
Distance between the two smaller holes is 1 7/16"

 

[buckroseau]

Large hole is centered on the center rib of the floor.

Center hole is 9/16"
Smaller holes are big enough for the screws to go through.
Distance between the two smaller holes is 1 7/16"

Thanks Mike, this might sound like a stupid question, but could you circle it in the pic? I can't see it?

Thanks, Matt

 

[foxfab]

 

[foxfab]

BTW, this is a 1964 if that matters.

 

[buckroseau]

BTW, this is a 1964 if that matters.

See it now, thanks Mike.

I would think it would be the same, but not sure?

Anyone else? Treeroot??

Matt