Mounting Dobs rear drawer help

[Cemeb4dk]

I'm trying to install my dobinsons rear drawer in my 16 gx 460. The instructions are not the best. Trying to figure out where the cross ribs go? The first one is obvious but the inner one has no holes to mount on truck? Any help is appreciated

 

[TX GX460]

I agree they aren't the best, and I made some of my own rails to fit the ribs. I have some pictures of my install starting on post 13 of my build thread: Builds - His and Her GX 460 Builds

Hope it helps.

 

[Cemeb4dk]

I agree they aren't the best, and I made some of my own rails to fit the ribs. I have some pictures of my install starting on post 13 of my build thread: Builds - His and Her GX 460 Builds

Hope it helps.

Thanks.so if I'm looking correctly you used that metal strap and bent it down over the front rear seat bolt holes and then ran it to the back. To create a support for under the rails? That's awesome and solves me drilling thru the floor and dropping spare and hoping I don't drill into a fuel line etc lol thanks

 

[TX GX460]

Yep that's what I did and why I did it. FYI, I later placed a wood block with a felt bottom under the cross brace for additional support so it wasn't flexing the metal strap under weight.

 

[Cemeb4dk]

Thanks for the help. I ended up using rivnuts in the rib of the floor where the front of the rear seats mount. Then used the holes in the very back where the back of the rear seats mount. I ended up having to trim about 1/8 of an inch off the driver side wings to let the fridge slide open more freely and trim off some of the metal bracket driver side along the rear seat.

 

[TX GX460]

Looks great! Glad I could help.