LX570 Bumper Build (9 Viewers)

[soccernut]

Looks good. Did you mean to have the lower side profile ramp down from the tire to the rear bumper? Most aftermarket bumpers that are aesthetically pleasing ramp up from the tire towards the rear.

Here is the Kaymar as an exampel:

Yes, I will be adding a lower section that's going to tuck in slightly and ramp down towards the tire

 

[soccernut]

MAJOR UPDATE:
Started work on the bumper. Decided to abandon the original design for a simpler design.
Got a lot done over the last few days. Right now the bumper is just sitting on top the hitch, I will have to fabricate a mount that ties into the recovery points using some 1/4" think L channel steel.

 

[soccernut]

 

[CanadianRockyCruiser]

Bumper looks good. I like the spare rotor mount. Never leave home without a spare rear rotor

 

[soccernut]

Bumper looks good. I like the spare rotor mount. Never leave home without a spare rear rotor

Haha. It was leaning forward when I placed it and wanted something to weigh it down. Lol

 

[soccernut]

Finished Product!!!

 

[grinchy]

Finished Product!!!

View attachment 3911179
View attachment 3911180

I can’t believe you got that sill trim off without destroying it, so it could be reused.

 

[sedole]

Great work!

 

[soccernut]

I can’t believe you got that sill trim off without destroying it, so it could be reused.

It wasn't too bad. It's held by clips on the underside. I unded up chopping them off so it can sit flush on the bumper