lj78 transfer case seals

[flyfishbc]

checked around the forum, couldn't seem to find any part numbers for transfer case seals. lj78 with 4 spd auto. any help would be appreciated. Front transfer case seal is leaking, and while im at it , what tranny and transfer case do i have. i'm a little confused here. Also will a 5 spd manual and transfer case out of a older 4 runner fit, will i have to change drive shafts etc,etc.

 

[kbushnz]

Down load the manual for
Land Cruiser KZJ 70 Series II - 1KZ-T Engine
From here Toyota Workshop & Repair Manuals - Page: 3
The section on the transfercase will answer most of your questions. (They are the same.)

Also goto http://www.toyodiy.com/parts/p_J_1991_TOYOTA_LAND+CRUISER_LJ78G-PET_3609.html
Item 36111B should be your seal.

Dont bother with a 4 runner transfercase....The LJ78 one is much stronger and the driveshafts on the 4 runner wont align.

 

[crushers]

if the front seal is leaking then i would check the internals for damage as well ...
of course if the seal went because of swamp grass getting caught around the shaft then that is understandable.
John at Radd Cruisers will have what you need as well.

 

[kbushnz]

Ahhh yes there are two possibilities for front seals .... Output shaft seal for front drive flange...36134A

 

[oldblue]

ToyoDIY.com

 

[flyfishbc]

thanks for the help guys. cheers

 

[flyfishbc]

my computer (MAC) won't open the manual link above. the seal i need is the one on the front of the t case, right where the front drive shaft comes out. there is just one drip down the front of the case. no drips on the ground. i don't think it s to serious. is this the 90311-48009 SEAL, OIL (for output shaft bearing front retainer) thanks for your help

 

[oldblue]

Yes that's the correct seal number

 

[crushers]

sheesh, no worries at this point. when it starts leaving toonie size drips everywhere then worry about it...

 

[flyfishbc]

thanks, your help is appreciated.