Hi All.
Im stuck. I've installed new parking shoes adjusted the shoe gear at the bottom to the smallest, loosened the turnbuckle on the cable until the cable has slack and adjusted the bell crank bolt all the way in. Im installing my new rear rotors and im still getting a little drag on and off as it rotates, like the shoes arent perfectly center. I've done everything right and went over all the available material. Any clues other than sand down the portion of the shoe that dragging. Its the leading side that moves the most.
Im stuck. I've installed new parking shoes adjusted the shoe gear at the bottom to the smallest, loosened the turnbuckle on the cable until the cable has slack and adjusted the bell crank bolt all the way in. Im installing my new rear rotors and im still getting a little drag on and off as it rotates, like the shoes arent perfectly center. I've done everything right and went over all the available material. Any clues other than sand down the portion of the shoe that dragging. Its the leading side that moves the most.