What!!! That sucks dude. Those Ron Davis radiators are beautiful. What did you do lol
Story time please
Liland all aluminum radiator
- Thread starter Clemson TLC
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
What!!! That sucks dude. Those Ron Davis radiators are beautiful. What did you do lol
Story time please
My costly mistake. The fan took a chunk off the top of my cracked shroud and gouged a big hole between the top tank and the tubes...What!!! That sucks dude. Those Ron Davis radiators are beautiful. What did you do lol
Story time please
My costly mistake. The fan took a chunk off the top of my cracked shroud and gouged a big hole between the top tank and the tubes...
View attachment 2959680
View attachment 2959679
That sucks!!! Did you check your motor mounts?
That was the first thing I repaired on my old 91. The motor mount was bad and the fan would hit the shroud under torque. I was lucky and fixed it before it ate the radiator.
yeah that happened a while back, i have since replaced both fronts and tranny mounts. I procrastinated on replacing the shroud.....ugh.
91 3fe here… and four years later my Liland is still working. During the intial install i did make sure the rubber bumpers were installed correctly as iit would help eliminate stress when bumping down the trail. Im using Toy red and distiled water, NOT pink its too accidic and caused the leak of two heater cores after a fluid swap.
Last edited:
Resurrection of this thread… can someone explain how the shroud fits on the radiator? Do you have to drill holes in the shroud?
FWIW, mine is still going strong.
Aside from my hosing the first 1/8” of the aluminum threads when (over)tightening the trans cooler fitting onto the nipple.
Anybody know the thread pitch?
Aside from my hosing the first 1/8” of the aluminum threads when (over)tightening the trans cooler fitting onto the nipple.
Anybody know the thread pitch?
To bad about the TYC.
If anyone cares, my Liland is still working just fine 4 yrs later, infact im gonna go tear up the oceano dunes tomorrow with my 91. She likes to stretch her legs in the sand.
If anyone cares, my Liland is still working just fine 4 yrs later, infact im gonna go tear up the oceano dunes tomorrow with my 91. She likes to stretch her legs in the sand.
4 years and keep going strong! I was looking for this kind of feedback, as I’m planning to replace my csf…
Specifically, do you remember which model of Liland is it?
LILAND GLOBAL 1469AA2R
Sorry to bother again and again, just wanted to have as much info as I could. I saw another liland (13AA) and wanted to know if that was the case.
i believe one is a 2 row and the other is a 3 row. I had both units, both fit our 3FE engine.
