Nice! I was going to say colostomy bag.
Lets play identify the part
- Thread starter hadji_85
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Nice! I was going to say colostomy bag.
Correct.
Mr Pardo will now announce Mr Romer's gift...............
The downside of building it in is that little loophole when you can buy a $45 button and get $2000 options
Not on an 80, but hey, it is still a valid comment!
Grench
SILVER Star
Hmm... Where is the other end of that tube?
It goes to a huka. Just warm the engine up and take a drag off the tube, you'll be amazed.
As Dan mentions sunroof drain - so what should I be looking for in terms of an exit routing for the roof drain tube? I'm getting tired of pulling the plugs in the bottom of the panel after a rain to drain the lower panel on the pass side.
Grench
SILVER Star
Seriously... Where does the other end of the tube come out of the harness?
I'm thinking a mildly pressurized water tank in the engine compartment with rear of truck distribution... Hot water on tap at the end of the day could be handy. Gravity or @ 10 psi should do it for moving it around without compromising that tube. A 15 psi pressure relief on the tank itself would prevent catastrophic failure of the tank if it were to over pressurize.
So, as a wise old plumber once taught me, "Every pipe has two ends." So, where is the other end of this one? It probably can't handle enough volume to make it worth it though.
I'm thinking a mildly pressurized water tank in the engine compartment with rear of truck distribution... Hot water on tap at the end of the day could be handy. Gravity or @ 10 psi should do it for moving it around without compromising that tube. A 15 psi pressure relief on the tank itself would prevent catastrophic failure of the tank if it were to over pressurize.
So, as a wise old plumber once taught me, "Every pipe has two ends." So, where is the other end of this one? It probably can't handle enough volume to make it worth it though.
Pressurize some water with a squirt gun and find out.
-B-
-B-
Required knowledge for wise plumbers:
1) Poo goes down hill.
2) Payday is Friday.
3) DO NOT bite your nails.
ok. ready for another round of identify that part? i was taking off my running boards and on the drivers side close to the rear mount for the funning boards there is a white plug coming out of the floor . any ideas what its for?
Pic? Could be a replacement drain hole plug. There are drain holes in the bottom of the body under the door sills.
Last edited:
sorry i dont have a way to post pics right now it a female wireing harness plug ...
You got me on that one. I am out of town, and not near my truck, or else I would go look for you...
The only plug I see there goes up and over the gas tank, so I'd guess it's for the gauge.
That's for the 1FZ, you don't say what vehicle you have so YMMV.
its a 1996 80 it very close to where the running board mounts . comes out of the floor with a large wiring harness and then just a white plug left over when i get the cruiser out of the shop i will take a pic
I believe that relates to the fuel transfer pump for vehicles with a sub tank.
Grench
SILVER Star
Aww - I was just about to tell him that it was the power plug for the factory underbody lighting kit only available in Dubai.
