The wife’s birthday is tomorrow and we just got back from vacation today so I’m likely not gonna make it out but I do have a list of stuff I gotta get done on the 60 before next weekend.
Last minute pre-GSMTR prep HAMMOM 6/4-6/5
- Thread starter AJR
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Stopped by for a minute to watch the boys hard at work @AJR, @IcutYourCruiser, @GLTHFJ60, and @UZJ105.
Didn't want to get my hands to dirty
so I took on camera duty.
Didn't want to get my hands to dirty
so I took on camera duty.
- Thread starter
- #24
Thanks to everyone that came out, got a lot of stuff done and had a lot of fun. It’s looking like it should be a good GSMTR this year.
Thanks for hosting us Adam! Had a blast as always.
I had a great weekend, right up until I didn’t.
Oh noo
Holy s***. Where did that happen?
On the exit ramp off 85 in Spartanburg. Luckily I was close to home. Called my brother in-law. He grabbed my trailer and came to the rescue. 62 is back at my shop, the Crasin is in the shop, and the new tire/wheel combo is on. It’s been quite a day.
Luckily it looks like the only thing damaged was the t-case output flange. I’ll grab a spare from trollhole’s tomorrow and slap it all back together. Hopefully the driveshaft is still ok.
Flange nut came loose????
Yep. I pulled it apart today and bolted a new used flange on. (Perks of working at trollhole’s). There was a mark from the nut being staked, so not really sure what caused it. Filled with gear oil and took it for a test drive. Bad vibration. I’m assuming the driveshaft is bent.
I guess count your blessings it didn't come up through the floor or send you pole vaulting.
