Hi everyone.
This is my first post on the forum and I am seeking some help.
I have acquired a 45 series cruiser which has had a 1hz put in it. The car has been off the road and I am slowly getting it restored.
I have now managed to get the engine to start fairly easily when cold with about 10 seconds of heaters it fires up. However once the engine is warm/hot it will not start at all even if you try with or without plugs.
I have checked everything which I can think of.
The starter has just been refurbished and the battery voltage goes down to about 10.6 ish when cracking which I thought was Ok?
There is 12 volts going to the IP soliniod and I can hear it click.
I have installed a new battery
I have installed an online filter just before the IP so I know the fuel is getting there. And I have also cracked open an injector which also has fuel.
I am a petrol mechanic so not too clued up on these engines. Any help would be much appreciated as I am pretty much out of ideas.
This is my first post on the forum and I am seeking some help.
I have acquired a 45 series cruiser which has had a 1hz put in it. The car has been off the road and I am slowly getting it restored.
I have now managed to get the engine to start fairly easily when cold with about 10 seconds of heaters it fires up. However once the engine is warm/hot it will not start at all even if you try with or without plugs.
I have checked everything which I can think of.
The starter has just been refurbished and the battery voltage goes down to about 10.6 ish when cracking which I thought was Ok?
There is 12 volts going to the IP soliniod and I can hear it click.
I have installed a new battery
I have installed an online filter just before the IP so I know the fuel is getting there. And I have also cracked open an injector which also has fuel.
I am a petrol mechanic so not too clued up on these engines. Any help would be much appreciated as I am pretty much out of ideas.