- Thread starter
- #81
The heat tweaked the bottom of the legs because of that unsupported 7" from the top of the bumper to the bottom rung. Metal moves when it gets really hot. If that was a rectangle with a lateral support at the very bottom you don't have to worry.
It's not a big deal. I just have to re work the bottom vice mount with taller angle so it reaches the bottom of the plate above it. No biggy. I knew it was going to move a bit but this was a little more than anticipated. All in all it's holding fine but it needs to be corrected. The gap pry looks bigger in photo than it actually is.
It's not a big deal. I just have to re work the bottom vice mount with taller angle so it reaches the bottom of the plate above it. No biggy. I knew it was going to move a bit but this was a little more than anticipated. All in all it's holding fine but it needs to be corrected. The gap pry looks bigger in photo than it actually is.