key chain and gear shifter knob

[PUPTLAM]

I was screwing around with the CNC machine, and my buddy showed me how to etch letters and numbers into the metal. I just had to make something so I made a couple of keychains. What good is a keychain without a matching gearshifter? I asked the size of the tap for the shifter and POSER said it was 8 x 1.25 for a 74 fj40, it was actually 10 x 1.75 which leads me to believe that I dont have the original tranny anymore. I have yet to get bad advise from POSER, and he has given me a LOT of great advise. So there's your tech.

 

[mtj555]

That might be pretty cool if you could etch in the shift pattern of your tranny. I know nothing of the CNC machine

 

[Eshu Elegua]

nice key chain

 

[dgangle]

put me down for a key chain.

seriously, you should make them and sell 'em through cruisercrap or on your own....

anything can be done an a cnc...just takes programming