- Thread starter
- #41
I am this week. The kiddos are in Georgia with grandparents.
Kermit's Make Over
- Thread starter CandyPants
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I am this week. The kiddos are in Georgia with grandparents.
- Thread starter
- #42
Ha ha! Don't be a dirty old man.
Bodean
Hot Damn
Can I be one?
- Thread starter
- #46
doing work
Is Bill wearing the other glove?
Michael jackson fans.
Thanks for doing all this work on my rig ; p
Thanks for doing all this work on my rig ; p
- Thread starter
- #49
Is Bill wearing the other glove?
There were 2. They were just for the same hand. Luckily they were both for the hand that was in the Sparks.
safety equipment isn't a big deal around here. Go figure.
I'm honestly surprised you had one glove to put on.
Bodean
Hot Damn
Should we send a safety care package? Gloves, safety glasses and ear plugs?
Clutchee
I'm fun sized!
Heather- what you gonna do with red coils in "scrap" pile?
If nothing- I could use them!
If nothing- I could use them!
- Thread starter
- #53
You got it Clutchee. There are only 2...but they can come to crawl in October.
- Thread starter
- #54
Clutchee
I'm fun sized!
Gracias mi Amiga!
Where is the unlike button? Gonna be okay?
- Thread starter
- #57
He's fine. He stepped into the scrap pile and jammed a sharp angled piece of tube into his foot. Bled like a stuck pig for a while but seems to be ok now.
I knew something was wrong when he went into the house and left a cold beer to get warm.
Well now we know what it takes to get Bill to abandon a cold beer...
Mend quick buddy!
Mend quick buddy!
Looks like he is in good hands
- Thread starter
- #60
Today we are going to mock up the link set up and figure out where all the brackets and what not go. So far the Ruff Stuff heims are perfect, but the Ruff Stuff brackets for the upper links on the front and back are too narrow for FC's spec. According to his drawings, for the rear upper links, we need 6" separation at the truss on the rear axle. So we are going to use the bracket that should be on the cross member for the lowers on the truss (for the uppers), and then use individual brackets for the mount to the cross member for the lowers. Thus we will delete the 3" spaced bracket and get a couple individuals to use for the lowers to attach the to cross member. We will need to cut off a couple of inches off the truss to get the right height.
