97 LX450 - just took off my front drive shaft chasing a vibration (happened to actually be the DS for once), however, when I was down there after disconnecting the axle side of the shaft I was not able to turn the front independently (back drive shaft would move in tandem). Truck was on ground while doing this, and transfer and trans were in neutral. I have a CDL but it was NOT on which is my concern - I was told front DS should spin independently by hand once you disconnect from axle side.
1.) is my VC shot?
2.) how do I test CDL switch to find out?
thanks!
1.) is my VC shot?
2.) how do I test CDL switch to find out?
thanks!