Insufficient privileges -thread link (1 Viewer)

[ERG80]

Hello woody, I tried to follow a link in post #6 of the thread below but was taken to an insufficient privileges page.
The thread:

Sway bar bracket

Anyone know where to source the broken bolt hole u shaped piece in the photo? Part #? It's from DS attachment point. Thanks! Thanks!!!

forum.ih8mud.com

I get an error from both links posted.

Is there anything I can do to get privileges to view them?

 

[ERG80]

@woody
sir, just wanted to bump this to see if there’s a solution so I can view those threads. Thank you.

 

[woody]

That was a private Clubhouse that has now been closed. Files are no longer available.

 

[ERG80]

That was a private Clubhouse that has now been closed. Files are no longer available.

It’s unfortunate to lose such helpful info.
Thanks for the reply.