Hey guys. When I get my quarter panels burned, I end up with some 3/16 plate left over. Depending on how many I get made at a time depends on the size and amount left over. Random size comes from the wheel wells and then a rectangular piece. Last run I made some (20) u-bolt spring plate sliders for a 40. I have been asked to make some roll bar mounts that fit the stock wheel wells. To make a hump in them to clear the sheet metal.
Let me know your ideas. I have to pay for extra burn time and then any bending etc but it can come out well. If I use your idea I will make you a heck of a good deal on the piece(s). I am not sure I want to make anything too complex. I thought about trans/t-case skid plates but that will take more metal and time, not that that is not an option. I know IPOR already makes a nice skid and not looking to take away from Lance.
Best bet is a DIY part that could be welded together later to save on cost.
Thanks in advance
Let me know your ideas. I have to pay for extra burn time and then any bending etc but it can come out well. If I use your idea I will make you a heck of a good deal on the piece(s). I am not sure I want to make anything too complex. I thought about trans/t-case skid plates but that will take more metal and time, not that that is not an option. I know IPOR already makes a nice skid and not looking to take away from Lance.
Best bet is a DIY part that could be welded together later to save on cost.
Thanks in advance