How to: Install a Tuffy security console in your 80/81... (1 Viewer)

[NexusD]

Do you have you have one yet? If so, take your stock console out and start playing around with placement. There really isn’t much to it at all. Figure out how you are going to do the 1” spacer and the rest is cake.

Yes I’ve pulled everything and I have been trying to fit in place using 1in Square aluminum tubing. My Plan is to use the existing mounting screws from the old Center Consol but now I may need 2 in square tube for the middle section and I can’t figure out how to mount the back section. Up front I was going to install the cup holder high up on the shifter area.

 

[Josey1972]

Yes I’ve pulled everything and I have been trying to fit in place using 1in Square aluminum tubing. My Plan is to use the existing mounting screws from the old Center Consol but now I may need 2 in square tube for the middle section and I can’t figure out how to mount the back section. Up front I was going to install the cup holder high up on the shifter area.

I ended up putting aluminum legs down to the floor from the corners in the back because it bounced around more than I liked.

 

[half k cruiser]

Yes I’ve pulled everything and I have been trying to fit in place using 1in Square aluminum tubing. My Plan is to use the existing mounting screws from the old Center Consol but now I may need 2 in square tube for the middle section and I can’t figure out how to mount the back section. Up front I was going to install the cup holder high up on the shifter area.

Use the mounting bracket that came with it across the back, you flip it upside down and extend it with some 1'' square tube.