Help: Mid 70s FJ40/55 turn signal high/low contacts

[ERNRAM]

Howdy,

Need a picture of the contacts from a side view for the low and high beam setting.

I bought an aftermarket one from Crusier Corps and it was junk. The horn went off when putting the high beams.

My old one functioned fine , just the leaver for the turn signals was cracked off at the end.

So i decided to swap the old electronics into the new mechanical.

I think i have it figured out except the contacts for the high /low beam look wrong.

Anyway someone can take pictures.

Ill post mine shortly

 

[ERNRAM]

The bottom leaf seems like it is not touching the left side contact

 

[ERNRAM]

This is the two views i really need.
In both positions (high and low)

 

[ERNRAM]

As you can see i have both of the leafs stacked on top of each other. Wondering if this is correct

 

[B y r o n]

If you have your old one which functions fine have you compared it against the new one? Side by side photos should show if there is anything different.

 

[charliemeyer007]

Center punch the old one, drill it for a steel pin like 1/8 inch OD say 1/2" deep. Drill the broken lever. Epoxy the 1" long pin in both holes.

 

[ERNRAM]

If you have your old one which functions fine have you compared it against the new one? Side by side photos should show if there is anything different.

I should have taken puctures before i swapped the electricals. Thats is why im asking for outside help

 

[ERNRAM]

Might just buy me a new OEM directly from Toyota. Some on Ebay i can tell even though they have a toyota part number on them are fake.

 

[ERNRAM]

Ebay fake the contacts on the leaf spring is not even on the corresponding pad