Same for me. I got it to go into vehicle settings a couple times but usually it just goes into the read codes mode and there's no clear or simple way to navigate out of it. Doesn't help that it's pretty damn slow.
Handheld Techstream Alternative Found! (1 Viewer)
- Thread starter Boston Mangler
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I just got the Launch Creader Elite 2.0 for my 2011 LX570.
I bought it to force the A/C actuator initialization. Only my driver's A/C vents blow cold air, and it's miserable to drive right now. Anyone been able to do this or successfully? It seemed like I could manually move the servos, but I was never able to get cold air coming out of the other vents. Seems like it connects and does what it should. I changed some settings successfully.
I think the culprit is error B1449 Air Outlet Damper Control Servo Motor Circuit (Rear). I'd like to be able to flash reprogram the A/C amplifier module, but I couldn't figure out if the Launch.
Any ideas? Thanks for getting this thread going...very helpful.
I bought it to force the A/C actuator initialization. Only my driver's A/C vents blow cold air, and it's miserable to drive right now. Anyone been able to do this or successfully? It seemed like I could manually move the servos, but I was never able to get cold air coming out of the other vents. Seems like it connects and does what it should. I changed some settings successfully.
I think the culprit is error B1449 Air Outlet Damper Control Servo Motor Circuit (Rear). I'd like to be able to flash reprogram the A/C amplifier module, but I couldn't figure out if the Launch.
Any ideas? Thanks for getting this thread going...very helpful.
