I am replacing all the rubber lines for the gas tank under the truck. I bought a 12" length of 17/8" diameter for the filler line. Problem is I got this wire reinforced hose that is super stiff. Near unbendable. Even with some heat put to it. Can anyone recommend a less brutish variety?
Fuel Filler Hose
- Thread starter Mhks68
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
@cruisermatt has a kit to replace all hoses that go to the fuel tank, including the factory hose clamps.
- Joined
- Jul 22, 2012
- Threads
- 584
- Messages
- 16,434
- Location
- Winter Park, Florida
- Website
- www.cruisermatts.com
Nothing fits better then the OEM part.
We are out of stock but will have them back again next week
We are out of stock but will have them back again next week
60 Series Filler Neck Kit
Most original 60-Series filler neck hoses are dry and stiff from age and can impossible to re-install if removed.With this kit you will receive not only the hose but also the filler pipe grommet and both clamps, all correct and genuine Toyota-made parts. Everything you need to address this...
cruisermatts.com
Throw that out. Get the proper factory piece as they are available. Don’t forget the rubber gasket that goes thru the lower rocker either. I had more trouble removing the screws that hold the cover below the fuel line and other hoses above
- Thread starter
- #5
CM- I’ve already replaced all the smaller lines and clamps. Do you sell just the large line, clamps and body gasket?Nothing fits better then the OEM part.
We are out of stock but will have them back again next week
60 Series Filler Neck Kit
Most original 60-Series filler neck hoses are dry and stiff from age and can impossible to re-install if removed.With this kit you will receive not only the hose but also the filler pipe grommet and both clamps, all correct and genuine Toyota-made parts. Everything you need to address this...cruisermatts.com
- Joined
- Jul 22, 2012
- Threads
- 584
- Messages
- 16,434
- Location
- Winter Park, Florida
- Website
- www.cruisermatts.com
Yes, simply select “Filler Neck Kit Only” on the website. We just got them back in stock and I’ll get the website updated in a little bit.
- Thread starter
- #7
Nice. How do I work with this?!? “Well I tell ya’ first thing ya do is throw that out! Then ya get the right part in there!”
Looking into parts from CM.
Thanks cruiserpilot.
There is a guy on mud. Dave - Japan4x4 who has access to parts. I useNice. How do I work with this?!? “Well I tell ya’ first thing ya do is throw that out! Then ya get the right part in there!”
Looking into parts from CM.
Thanks cruiserpilot.
Megazip.net because it has expensive parts diagrams and tells you how many of
what part you need and the actual Toyota part numbers. So you can at least have the correct numbers
to look at other sources.
I am sorry if a bit blunt but I’ve found over the years the proper part for this kind of thing
is the only way to go, and money spent properly is always best.
It avoids that ‘ putting good money after bad’ to correct something not done right.
