Front Sway Bar Bolt Size?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 4, 2016
Threads
36
Messages
365
Location
Minneapolis, MN
Anyone know the size of the front sway bar link bolt (part# 90119-10765)?

I ordered an oem bolt online but would like to throw a bolt in there for the next few days until the oem part arrives.

Thanks friends,
Ben
 
If you don't have the old bolt to match-up at hardware, perhaps you can pull other side. ACE has good selection, even better is at A&A (ACE) on SO Broadway.
 
It's an M10 1.25 pitch. You want about 30mm of unthreaded and a total length of 45mm. I went with a 55mm bolt since it had a 30mm unthreaded area.
thanks so much for posting this! I had to cut off my old bolt before realizing the nut was welded onto the mount. So to get the stub out, i had to drill it out, but now my threads are trashed, so I'm a little stuck whether to try and tap it, or just find a locknut to fit on and buy a slightly longer bolt.
 

Users who are viewing this thread

Back
Top Bottom