The yoke on my front FJ62 driveshaft is bent. I need to either find a good used one, have a local machine shop replace then balance my DS, or find a new one. Any suggestions from the local cruiseheads?
Front Driveshaft fix (1 Viewer)
- Thread starter JScott
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I used automotive driveline supply in Hurst off of 10 and Precinct Line. I'd highly recommend them.
808 W Hurst Blvd
Hurst
(817) 284-8187
HTH,
Nick
808 W Hurst Blvd
Hurst
(817) 284-8187
HTH,
Nick
I just had Fort Worth Gear and Axle replace the u-joints and balance mine.
I'm going to have to replace it, though, with a driveshaft with a CV joint on the transfercase side.
So, I'm going to sell mine, but it may be a little while before I'm ready to part with it.
I've gotten lots of good parts from Georg at Valley Hybrids in California (orangefj45 here on mud). You might contact him if you need something soon.
I'm going to have to replace it, though, with a driveshaft with a CV joint on the transfercase side.
So, I'm going to sell mine, but it may be a little while before I'm ready to part with it.
I've gotten lots of good parts from Georg at Valley Hybrids in California (orangefj45 here on mud). You might contact him if you need something soon.
- Thread starter
- #4
Thanks for the information. I will call Georg and the driveline supply in Hurst. I have a few other mud offers for used ones too. Hopefully I can get some of my driveline vibration fixed, new 3rd member will do the rest when I have the cash.
I used them for a couple of drive lines also, as has another friend on his SOA 60.