Front Axle index Ring Advice (1 Viewer)

Joined
Dec 18, 2010
Messages
35
Location
Sandy, Utah,U.S.A.
Finally getting to my knuckle rebuild, going well, but nudged my index ring loose on one side. Upon repositioning I notice it is slightly bent and has a bit of a bur on one edge preventing it from seating properly, I can get it in, but it doesn't seem to be holding in firmly, like I might bump it out when the driveshaft goes back in. Tried to order the part and was advised to try a used one from Classic Cruisers. Saw a thread where someone cut one in half and spot welded one half on each side, and one old one where Cruiser Dan said one must purchase a new complete axle :) any thoughts or advise on the matter would be greatly appreciated, thanks Mudders.
 

Users who are viewing this thread

Top Bottom