Flare sticky tape (1 Viewer)

[Bear80]

So I pulled my flares off, not for good but only to replace the cracked rubber. After removed, the rubber left the foam tape to the body. What is the best way to get this adhesive off.....its pretty strong stuff. I haven't tried wd40 yet but I'm sure there is somthing better out there.

 

[psj1945]

"goo-be-gone" and a plastic putty knife should take care of it !

 

[T Y L E R]

Try a 3M wheel on a power drill .. go lightly . I bought and used one when I put new badging on my 80 . Sometimes guys will try dental floss ahead of time to cut off the bulk , and use the wheel for the finishing .

TY

 

[NorCalDoug]

Dental floss is crap.
Not strong enough.
Use a low lb test fishing line for better results.

I used the goo remover stuff and my thumbnail. Geez, what a crappy job that was.

 

[Kaderabek]

I used lighter fluid. Worked fine.

TJK

 

[Beowulf]

So I pulled my flares off, [... ] but I'm sure there is somthing better out there.

SawZall.

-B-

 

[ginericLC]

I've used some stuff called Goof Off! it works pretty well and isn't so hard on the paint. A heat gun and an adhesive eraser also work well if you have access to body shop tools.

 

[sea2skydad]

Ditto the Goof-off and "What a crappy job that was." They look way better now with the Rhino Liner.