Fj60 same as Fj62 steering column ?? (1 Viewer)
- Thread starter In2cruisers
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
To my understanding, the mechanicals are the same, however I believe the ignition switch and wiring harness is not the same.
cruiserinsanity
SILVER Star
Yes, they are interchangeable. My ‘85 Fj60 has a ‘88 FJ62 column in it and my Dad’s ‘86 Fj60 has a 62 column also.
- Joined
- Jul 22, 2012
- Threads
- 575
- Messages
- 16,154
- Location
- Winter Park, Florida
- Website
- www.cruisermatts.com
This is correct - reuse your original ignition switch or replace with new 60 one
Aren’t the switches different?
cruiserinsanity
SILVER Star
Yes, the switches are different but they can be swapped between the columns.
The FJ60 ignition lock cylinder 8/80-9/87
&
The FJ62 Ignition lock cylinder 10/87-1990
Are different profiles slightly , but most importantly the depression pin you use the hand-held drift-pin with the key in the ACC position to release and remove both ignition lock cylinders are in different locations , and the pin-bore holes are notably different in diameter ...
not sure about the electrical key switch side of things ?
i suppose this might be what was being kid-glove'd below ?
.
,
&
The FJ62 Ignition lock cylinder 10/87-1990
Are different profiles slightly , but most importantly the depression pin you use the hand-held drift-pin with the key in the ACC position to release and remove both ignition lock cylinders are in different locations , and the pin-bore holes are notably different in diameter ...
not sure about the electrical key switch side of things ?
i suppose this might be what was being kid-glove'd below ?
.
,
Last edited:
