FJ60/62 Tailgate and Quarter panel storage lids

[socallove]

Unless I have a truck here with those variants, I won't be able to make them, cutting it off and leaving the original box is a good option. I can make the box close to oem look but that will be more time and money but it will look pretty sweet.

 

[socallove]

just found out there's nothing in that box, can anyone confirm this?

 

[franklin40]

the blue plastic box over the wheel well? that's just a cover that goes over the seat belt reel.

 

[socallove]

Ok so if you intend to keep the cover, then it has to be cut off. NLXtacy sent a picture of his FJ62 with the panel on, no seat belt cover.

 

[socallove]

Another pic

 

[NLXTACY]

Mine is an 84 60 series not 62

 

[socallove]

Thanks for clarification, my bad for assuming.

 

[franklin40]

to you too!!

anyway I assume that would be a truck with just lap belts and no shoulder belts. if I have to cut the end off that's not the end of the world.

 

[socallove]

Measure this for me @franklin40 or @reevesci
From the edge of the door trim into the vinyl side panel.

 

[franklin40]

8 3/4 inches from trim edge to trim edge

 

[socallove]

Thanks! the left side, is it straight down, no angles like the door side?

 

[franklin40]

yes. exactly the same measurement too

 

[socallove]

I have some bad news and some bad news. it looks like I'm only making four sets of these panels and all four are tentatively sold.

 

[pandasfj]

was looking forward to purchasing....do you plan on making some later?

 

[socallove]

was looking forward to purchasing....do you plan on making some later?

If I can get 4 more sets pre-ordered, I can purchase material for it to arrive this week. But time is not on my side.

 

[socallove]

Just to be up front, these are $850 shipped for both sides with two stainless latches and hardware and speaker cut out, paypal gift.

 

[pandasfj]

Well I'm in. my speaker is a 7" round (18cm ) I would prefer a one piece full panel. I would not use the cover and do a cut out for the seat belt retractor.

 

[erse]

If I can get 4 more sets pre-ordered, I can purchase material for it to arrive this week. But time is not on my side.

How would you do payment for preorder? paypal invoice? Deposit or whole amount?

 

[socallove]

SO here's the final run down for these panel storage.

3/16" aluminum
Aluminum piano hinge
2 stainless steel latch per side
stainless steel button-head socket cap screws
Speaker cut out

Payments will be taken through paypal $775 for merchant, $750 using friends and family.
I prefer to have payment upfront, I will treat these as custom ordered due to time restraint. If you have a special circumstance, please PM me, I'm a reasonable person to deal with as long as you are reasonable.
Shipping is extra

If you have any questions, please PM me or call me.
@erse

 

[socallove]

This is the final drawing, both sides will be symmetrical, the hole in front is for wiring. If you don't want that hole, I can delete it.