Anyone know where I can find replacements for these vents? thank you.
FJ43 Replacement Parts
- Thread starter ATXFJ43
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
think those are aftermarket
Living in the Past
SILVER Star
This is probably a Columbian made top. No support thru Toyota so need to figure out who made the top and id they are still in business. There were a couple of different manufacturers of tops in Columbia.
I would think you could 3D print a two piece unit that would snap/screw together, and slide to close or open in order to block or let air flow. Glue or screw them in place.
Kick and cowl vents plus the windows down works for me. Be nice to add some flow threw vents at the rear to help syphon out heat or moisture. I don't sit in the back, and the wolf dogs just crowded the windows.
Kick and cowl vents plus the windows down works for me. Be nice to add some flow threw vents at the rear to help syphon out heat or moisture. I don't sit in the back, and the wolf dogs just crowded the windows.
- Thread starter
- #6
thanks
- Thread starter
- #7
Looking to replace bulbs in these Lamps. Anyone know if the bulb pulls out of that socket or do i replace the whole harness? Thanks in advance.
Those are Cibie Driving Lights, use H1 bulbs, with positive wire….available at O’Riley, Autobone, etc…
- Thread starter
- #9
thank you
- Thread starter
- #10
Quick question. Do I remove the wire at the base of the bulb or the connection left of the sleeve in attached picture? thanks.
Last edited:
Connection in the sleeve. When you buy a new one, make sure it has the wire…..take the old one with you if unsure.
