I am about to start rebuilding a 3-speed tranny that
is new to me. The tranny seems fine but there is
a slight bit of play of the first gear on the output
shaft. The shop manual has no guidance as to
how much is too much. If I could measure this play
it would be in tenths of a degree -- not much but
not ZERO play either. Should I quit worrying about
it and just re-build?
is new to me. The tranny seems fine but there is
a slight bit of play of the first gear on the output
shaft. The shop manual has no guidance as to
how much is too much. If I could measure this play
it would be in tenths of a degree -- not much but
not ZERO play either. Should I quit worrying about
it and just re-build?