Finally found a cup holder that does what it should (2 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Hey i found this thread, wanted to know if this wil lfit in my 1996 land cruiser? I just picked up my 96 this past week and i gotta get something that will fit right.
 
HorseHeaven - the one I have for the. 80 series fits all of them from 91 to 97. The area in the center console is the same.
 
I got mine on Saturday and got it installed in my girlfriends cruiser. This is the fourth cup holder I bought, and finally, this is the one that actually works.
 
Yea, that's what I needed too. Finally, this one fits right where it belongs!
 
I just tried to order one from your site and it says:
"Sorry, we are not accepting payments from your region at this time."
 
I just tried to order one from your site and it says:
"Sorry, we are not accepting payments from your region at this time."

well, it is montana
 
Not sure what the issue might be but you can PM me and I will get you the PayPal information
 
Cup Holder is now available in naked stainless, hammered finish steel gray. Cut another 25 last night.

Has anyone tried other colors?
 
+100000xxx for an LX version. Hell, you could probably remove the factory sub grille/mesh and would have room for TWO side-by-side cupholders. If that wouldnt be a big seller, then I dont know what would be! If I was closer I'd donate my truck for the cause...
 
+100000xxx for an LX version. Hell, you could probably remove the factory sub grille/mesh and would have room for TWO side-by-side cupholders. If that wouldnt be a big seller, then I dont know what would be! If I was closer I'd donate my truck for the cause...

I'm working on one for the lx 450. Console arriving soon.
 
The cup holder that I sell leaves all the switches accessible, it's in stock, inexpensive, and works great.
 
The cup holder that I sell leaves all the switches accessible, it's in stock, inexpensive, and works great.

I'm not saying yours block any switches, just that the one I bought from Gamiviti has a switch hole precut in it to allow you to install another switch on the cupholder.
I'm not affiliated with Gami so I don't know if they are out of stock or not. Price; I'm sure you have them beat.

I love anything with TEQ on it, if I didn't have one from Gami I'd buy yours in a heartbeat. :-)
 
I have that :flipoff2: I'm taking about one where the center speaker was. There is a mesh cover there that is begging for love.
Just swap the whole console for one from an 80, thats what I did and never looked back.
 

Users who are viewing this thread

Back
Top Bottom