Yesterday we rebuilt both knuckles, bearings and wheel bearings and new rotors. Everthing went really well but noticed something really odd. The trunion/axle has slop before and after the rebuild. After installing the dust cover and spindle(w/ pressed in brass bushing) there is slop on the axle. By grabbing the grooved end of the axle exiting the spindle the axle moves around. Is this normal, nothing really holds this in concentric anyway. We did notice small wear, pitts inside the brass bushing area on the spindle probably where the axle is rubbing/hitting. Both side showed wear but were the same no more or less than the other side.
Thanks for the all of the suggestions, links to do the job. It looks daunting but actually simple if you have all the tools, FSM, Georges link and Beowulfs parts sheets.
Thanks
Chris
Thanks for the all of the suggestions, links to do the job. It looks daunting but actually simple if you have all the tools, FSM, Georges link and Beowulfs parts sheets.
Thanks
Chris