Remembering I am not a welder yet. The rust in the outer radius should just be cut out and replaced correct? What about the rust where the fender and the skirt are joined... I plan to just media blast the heck out of it to get the flakes out and spray rust converter and paint. I realize that is not an important are to worry about rust but this is my first time doing all this and want to get other opinions. I am also thinking of the MT tube fender kit. Would that sheet metal be ok to make my own finish kit for the tube kit? thanks again.
Brad
ps also I think that the po had some type of liner sprayed under the fender. I have just been torching and scraping. Are there anyother ways to get that stuff off... am I wasting time? will the media blaster do it faster?
Brad
ps also I think that the po had some type of liner sprayed under the fender. I have just been torching and scraping. Are there anyother ways to get that stuff off... am I wasting time? will the media blaster do it faster?