Fender flare gasket

[DUCATISTA]

I just did my 94, cut to fit off the longest rubber. OEM is the way to go. I also got new hardware too, nothing better than tight fitting flares with new gaskets and hardware! I'm a with flares sort of guy.

View attachment 2373254

Haha

 

[FIDO96]

Quick question. I ordered 2 front fender, two rear door and two rear panel. The body shop said I need a left and right. I don’t see that in any part diagrams, but do see a lot of posts about using the front fender for all 6 locations by trimming to fit.

Are the OEM side specific or is the body shop just not looking at it correctly.

 

[JoeCova]

Quick question. I ordered 2 front fender, two rear door and two rear panel. The body shop said I need a left and right. I don’t see that in any part diagrams, but do see a lot of posts about using the front fender for all 6 locations by trimming to fit.

Are the OEM side specific or is the body shop just not looking at it correctly.

It’s just a roll of trim. If I recall not all pieces are still available so you buy extra front pieces to trim. I have a set in my garage atm. They aren’t side specific.

 

[ajax1]

I e done two of my 80s with just the front fender part number. The only difference between buying the correct piece for each flare is you Wil have to cut the correct length, on the rears, not difficult