- Joined
- Jun 21, 2011
- Threads
- 234
- Messages
- 21,836
- Location
- Redding, California
- Website
- trail-tailor.com
I have them now, just need to make up some more and get them on the website. Today or tomorrow.
Jason
Does anyone have the Trail Tailor rear lower arm skids?
- Thread starter Hammeredsole
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I have them now, just need to make up some more and get them on the website. Today or tomorrow.
Jason
@TRAIL TAILOR , I am installing these, now. My kit only came with 2 washers and all the pictures show a washer on the bolt head side. Is this correct? The website said 4 washers provided, but the bolt would be too short if I used another washer and I only received 2.
If anyone knows which side should have washer, please confirm.
If anyone knows which side should have washer, please confirm.
- Joined
- Jun 21, 2011
- Threads
- 234
- Messages
- 21,836
- Location
- Redding, California
- Website
- trail-tailor.com
Washer to head side. Bolt up, tighten about 50% and add the second washer on the back side. There should have been 4 washers... Sorry about that. You can re-use the stock head side washer as well.
J
Do you have specs for washer? My factory head side had a flanged bolt with no washer. I am going to use both washers on one side and will have to pick up a couple more so I can do the other side.
- Joined
- Jun 21, 2011
- Threads
- 234
- Messages
- 21,836
- Location
- Redding, California
- Website
- trail-tailor.com
Sac Cerevisiae
Reid
I just realized my rear LCA kit came with no washers. I did get an extra bolt.
I’ll need four (4)?
I’ll need four (4)?
I posted my question in the wrong forum. Sorry for any confusion to 200 owners. My question was related to the 100 series version.
