- Thread starter
- #121
Last couple weekends/ weeks been working on trying to get the interior back together. Made significant progress this weekend.
Started laying out a rear storage system.
Pretty happy with this orientation. Fridge will eventually go on a 36" slide that will be part of version 2.0. Got the base finished up after dark on Saturday night.
I put a temporary backer on so I could lay out some electrical components. Amp and power distribution mounting in front of the fridge.
And with that located I set my aim on finishing up the heat and sound deadening so I could finish wire placement.
Passenger floor pan got rhe same treatment as the D.S..
Rear floorboard got a layer of peal and seal since the 3FE exhaust crosses right under the floorpan here.
Then I finished up wire routing. RCAs and turn on run right up the middle. Main power and PS speaker up the right side. DS speaker and coax for back-up camera down the left.
With everything zip-tied and bundled, I think I am ready to put rhe carpet back in.
I have to pick up a few things tomorrow to finish up v1.0 of the rear storage and then I will pull it out and raptor line it, then should be ready to bolt in and do final wiring.
Once I've got that knocked out I just need to wire up the head unit and sort out the components for the front doors and throw in a new fan speed relay and the inside should be good for a bit.
Got to get some mirror repair brackets ordered and do an oil and diff change and then I'm gonna try my hand at the AC again.
I've got a kit to desmog it, but we'll see if I have time for that before KY in a few weeks. If not, that will be on the list for when we get back. Along with the fridge slide and a non-abs 93-94 master upgrade. Ole Bruce is shapping up to be a solid driver.
Started laying out a rear storage system.
Pretty happy with this orientation. Fridge will eventually go on a 36" slide that will be part of version 2.0. Got the base finished up after dark on Saturday night.
I put a temporary backer on so I could lay out some electrical components. Amp and power distribution mounting in front of the fridge.
And with that located I set my aim on finishing up the heat and sound deadening so I could finish wire placement.
Passenger floor pan got rhe same treatment as the D.S..
Rear floorboard got a layer of peal and seal since the 3FE exhaust crosses right under the floorpan here.
Then I finished up wire routing. RCAs and turn on run right up the middle. Main power and PS speaker up the right side. DS speaker and coax for back-up camera down the left.
With everything zip-tied and bundled, I think I am ready to put rhe carpet back in.
I have to pick up a few things tomorrow to finish up v1.0 of the rear storage and then I will pull it out and raptor line it, then should be ready to bolt in and do final wiring.
Once I've got that knocked out I just need to wire up the head unit and sort out the components for the front doors and throw in a new fan speed relay and the inside should be good for a bit.
Got to get some mirror repair brackets ordered and do an oil and diff change and then I'm gonna try my hand at the AC again.
I've got a kit to desmog it, but we'll see if I have time for that before KY in a few weeks. If not, that will be on the list for when we get back. Along with the fridge slide and a non-abs 93-94 master upgrade. Ole Bruce is shapping up to be a solid driver.
