Any creative ideas on blacking out the fog light covers on a 13'-15' model? There are off-the-shelf solutions for all other years, but not this range. Assuming spray-on dip is probably not wise for the front of the vehicle? Thx!
Blacking Out Fog Light Covers '13-'15
- Thread starter Recon Aircrew
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Remove them, take them to any local autobody shop, have them primed, painted, clear-coated, re-install.
- Thread starter
- #3
Unbelievably, found a pair for $10.99 that I can have painted...
Does anyone know if I will have to remove the bumper fascia to access them, or can I just peel the wheel well plastic aside?
That's an awesome price, even if it's an aftermarket set.
Looks like you'll have to pull the pieces out from the back of the bumper skin. You can probably access them from underneath, without having to remove the entire skin.
ATwoZ
SILVER Star
I used Amazon product ASIN B078X36BX2 with a low temp heat gun on 2010 LX Fog trim...required some inventive cuts to allow for the odd contours- black is almost a perfect match and you can't tell it was a wrap unless you're right on it.
Dirt hides it well, I can snap a better pic if you want.
Dirt hides it well, I can snap a better pic if you want.
Last edited:
Vinyl wrapped here. No removal of bumper needed. If you are going to remove the surrounds, I do not think you would have to remove the bumper cover, but you will have to remove a lot of the liners which is the hardest part about removing the bumper IMO.. I would say you would be 75% there based on my experience. I removed the bumper to replace my headlights recently.
- Thread starter
- #7
Looks fantastic. Thanks!
