BJ40 Starter (1 Viewer)

[stevebradford]

Did you swap to a nine tooth starter gear?

(a gear (9 tooth) has to also be swapped over when you have a non gear reduction starters

It’s likely the starter gear is not engaging with the flywheel properly. the flywheel has a different tooth pattern between the non gear reduction early starter and the gear reduction middle also unavailable starter. The gear you need and info the make your new starter work be found in this thread.

b and 3b starters and flywheels

Well today I thought I would put my 'NEW 3b Rebuilt starter" in my old "B" engine since the old one was out it went really easy, That was the end of a easy time turned the key and the starter spun but didn't engage, took it back out checked it out drive pops out like it's supposed to.everythings...

forum.ih8mud.com

 

[CostaCruiser84]

Hey @stevebradford, we did not, but after removing the starter it looks like you're exactly right. Though we took it to a starter guy this morning who said he needed an additional part(s) to swap the 9 gear with the 11....I haven't dug through that forum link you sent me but I will later today and hopefully it will shed some light...thanks

 

[CostaCruiser84]

@stevebradford that did it. Swapped the gears and she started right up! Thanks.