Hi,
I am about to change my bearings out on my HDJ81 and am following the FSM. It states to use plastigauge and torque to 27ft lbs then 90°.
My question is it ok to use these new bolts again after torquing them to the stretch factor during plastigauging for the final button up of the new bearings? Or do I need fresh bolts?
I am about to change my bearings out on my HDJ81 and am following the FSM. It states to use plastigauge and torque to 27ft lbs then 90°.
My question is it ok to use these new bolts again after torquing them to the stretch factor during plastigauging for the final button up of the new bearings? Or do I need fresh bolts?