Bearings used in Sean Huston Fabrication Dual Swing out bumper (14 Viewers)

[ekimatuan]

Hello,

I am getting my bumpers, rack, and sliders re-powder coated. As we removed the Sean Huston rear bumper and disassembled it, we found that the bearings in the swing outs are toast. The bearings don't have any legible numbers on them for me to try to match them up.

I searched the Forums for Sean Huston, Huston Fabrication, etc. but can't seem to find a way to contact him.

Any ideas on how to get a hold of him or does someone know what bearings these are?

Thanks in advance for the help from this community.

 

[Kernal]

You could measure the ID (bore), OD, and Width of the old bearing then search for that size Example: 20x47x14 (mm)

 

[ekimatuan]

You could measure the ID (bore), OD, and Width of the old bearing then search for that size Example: 20x47x14 (mm)

Thanks, that will be my fall back plan if I can't get a specific part number. The bearings are pretty hammered and falling apart so I hope I'll be able to get accurate measurements if I it comes to that.

 

[Kernal]

Can you post up a couple of photos of the old bearings (each side and standing up, with a ruler next to the bearing)?

 

[ekimatuan]

 

[Kernal]

OK, so roller bearings. There appears to be some stamped lettering still visible, can you take a wire brush and/or a 3M Scotchbrite type pad to remove
some more of the rust over the lettering?

 

[Marvelicious]

Just at a casual glance, those look like motorcycle headstock roller bearings to me, which would make sense as they see similar types of force. I'll bet All Balls Racing could help you out, just based on dimensions.

 

[ekimatuan]

I didn't think I'd be able to clean it up any more. Hit it with a stainless brush on my drill for a few minutes and got it legible. Thank you for the nudge there.

Dexter
Fusion Inc
010-019-00

I assume that this kit will likely work: 3500 lb Trailer Bearing Kit – Dexter Compatible | Trailer Parts Outlet - https://thetrailerpartsoutlet.com/products/3-5k-3500-lb-capacity-bearing-kit

 

[robnicko]

Kaymar swing outs use Holden 'trailer' wheel bearings - commonly found in most auto shops in aus stock them but the below link shows the specs

Your pics look very similar

Timken LM (Holden) Bearing Kit - The Trailer Shop

Timken LM (Holden) bearing kit. Trailer wheel bearings comprise of two parts, the cup which is pressed into the hub...

www.thetrailershop.com.au

 

[Kernal]

The Dexter 010-019-00 is a seal for a trailer bearing. There should be more (smaller) lettering on the bearings themselves (see photo in robnicko's post above)

 

[Mandrake]

Take the bearings to a trailer shop and have them match 'em up with some wheel bearings. Super simple.

 

[ppc]

The races will need to be replaced as well. Pop them out and take them to the bearing shop with the bearings.

 

[ekimatuan]

The Dexter 010-019-00 is a seal for a trailer bearing. There should be more (smaller) lettering on the bearings themselves (see photo in robnicko's post above)

Cleaned up the bearings again just to be sure and there aren't any additional markings. I will try to take them to a trailer shop today to see if they can help me match them up.