Back to factory stereo wiring... (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 22, 2014
Threads
3
Messages
4
Location
Oklahoma
Hello all!
New to 80's and posting on mud. Tried searching on this topic and have not had the luck I was hoping for.

I have a 97 LX450 and somewhere along its past an aftermarket stereo was installed.. trouble is they hacked up the harness and cut the speaker wire at each of the speakers. Then they ran all new wire to each speaker. I have sorted the trucks harness all back to the speakers. The real issue is the radio harness. I purchased a factory replacement harness but I am having a hard time sorting which wire goes to which speaker, constant power, acc, etc. Does anyone happen to have either a schematic of the factory plug or a picture of a factory plug with the wires showing a bit so I can rebuild mine? Perhaps someone has a picture of a factory harness with an install harness plugged in so I can repair that way as well? Thanks in advance for any help
 
Try this

 

I just did mine and ripped out the factory speaker wires and ran new OFC 14 gauge.

20190806_122034.jpg
 

Users who are viewing this thread

Back
Top Bottom