Hello,
I've installed my new Bump It Offroad step sliders today, and it was fairly easy using using jack stands. I'm not sure how best to avoid the brakelines that run along the frame on the drivers side, but have used bolts as spacers to move the lines out of the way of the U- bolts. The rear U- bolt is the most difficult and I have wrapped it in orange tape that is seen in the photos. It misses the U-bolt by a mm. Not sure how others have done avoided the lines?
I've installed my new Bump It Offroad step sliders today, and it was fairly easy using using jack stands. I'm not sure how best to avoid the brakelines that run along the frame on the drivers side, but have used bolts as spacers to move the lines out of the way of the U- bolts. The rear U- bolt is the most difficult and I have wrapped it in orange tape that is seen in the photos. It misses the U-bolt by a mm. Not sure how others have done avoided the lines?