ARB dual compressor mount: Slee or SDHQ? (1 Viewer)

[Boston Mangler]

I ran the dual compressor without the manifold kit for a few years on previous vehicles and it led to the first few feet of the air hose getting insanely hot. I installed the manifold after the original hose failed due to high heat.

Agree 100% on this!

I've had 2 failures where the hose out of the compressor got to hot and went kaboom after it melted away from the fitting.

I have added the manifold now and zero issues with it running non stop to fill (4) 42" tires.

 

[Eggrollz]

Yes I would make sure those power wires aren’t touching or draped over. It was hard to tell from your photo.

Thanks! It’s zip tied up and away from the pipes

 

[speakout525]

I used the SLEE bracket and frankly wish I had gone with the SDHQ. While I do not have any rubbing or powder coat issues, the fit is so incredibly tight it makes any adjustments very difficult and particularly makes working w/ wiring and the fuse box a PITA. The passenger side is just much more roomy and generally left unused in my application.

 

[bloc]

I had to loosen my slee mount once to wire in a light bar. It sucked. But I will do that one or two times more for the rest of my ownership.. I still think it's a better product when comparing the two.