Anyone successfully install flush mount LEDs into a bumper (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 15, 2022
Threads
58
Messages
324
Location
Atlanta, GA
Looking for mud member pics and advice on best way to cut into a steel bumper to mount a pair of fog LEDs - either into the stock or aftermarket bumper. Always hard to cut perfect squares with a circular angle grinder/cutter.

1-23-Tan-FJ40-Bikini-top-15-scaled-1.jpg
 
While I'm not a huge fan of those lights... the best way to cut squares with basic tools is mark all four corners of the square. Drill the corners out with a fairly large drill bit (probably 1/2" or so). Then use an angle grinder and connect the outer tangent of the holes. Now you have nice rounded corners and you're not trying to make the corners with the wheel.
 

Users who are viewing this thread

Back
Top Bottom