ALU skid plate

[SamoL]

Here are some pictures of my skid plate. It's not much, but it's better then the plastic one . Just a 6mm aluminium plate with holes.

The part between the wheels is still plastic:

Steel reinforcement bar can be seen here:

This is a look from above (torsion bar on the left, Tbox on the right):

Regards
Samo

 

[LandCruiserPhil]

Nice fit

 

[calamaridog]

I'm planning on doing something similar eventually. When I'm done, I'll post my pics in the same thread

 

[EL_3grab]

i want to do this but with plastic boards .. from the nose tell the T-case .. 1 inch thick ..

 

[spressomon]

SamoL,

Looks good. Did you make it yourself? Don't by chance have the pattern do you? The whole belly plate thing is on my list of 'to-dos'...one of these days I am going to tackle it!

 

[calamaridog]

Dan,

The plastic thingy is your template

 

[spressomon]

Dan,

The plastic thingy is your template

I guess I'll have to look at it again...it has been off the rig for over a year....but I didn't think it was flat to all 4 corners.

 

[calamaridog]

I guess I'll have to look at it again...it has been off the rig for over a year....but I didn't think it was flat to all 4 corners.

It's not flat but it may help with laying out some of the mounting points for whatever you end up fabricating.

 

[subspd]

:bump: