AHC - Techstream how to (1 Viewer)

[jsix321]

I’ve got a 08 LX570 and the driver side of roughly an inch lower than the passenger side. I’d like to do a sensor lift, but would like to level my rig before then with Techstream. I’ve already ordered and have the cable, just need a little help on where to go from here.

I’ve been searching and googling and haven’t found a good thread or posting that describes how to adjust height offset from side to side, can anyone help with this?

Thanks and sure it’s been asked many times before, just can’t seem to find something that makes me feel comfortable enough to go for it.

 

[lx200inAR]

The short answer is you probably can’t with just techstream. Here is the most recent thread on the topic. Lots of good info in there.

Thread 'Solution to intermittent AHC lean?'
Solution to intermittent AHC lean? - https://forum.ih8mud.com/threads/solution-to-intermittent-ahc-lean.1279286/

 

[jsix321]

Thank you for the reply. @lx200inAR

 

[lx200inAR]

If you just want to see some notes on the offset utility, there is also this thread. I don't think everything in this thread is fully baked, but it's a good place to start.

AHC Height Offset Utility How-To

Height Offset can adjust a maximum of .8", so you move the physical sensors first, and then you have .8 to play with. 1mm of movement on the sensor equates to 2mm on the rig. In theory, assuming there’s enough stoke in the shocks, you might be able to add .8” on top of the “sensor lift” method...

forum.ih8mud.com

Sometimes google is a better way to search mud. Try this link and notice the syntax of my search. (i.e. adding "site:ih8mud.com" to your search)

site:ih8mud.com height offset utility - Google Search