I'm looking for a decent looking A Pillar mount to fit my PLX unit into. I've searched high and low and can't find anything specific to this application. Does anyone have any recommendations for aftermarket 60mm gauge mounts?
Aftermarket A Pillar Gauge?
- Thread starter 00N8
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I used one meant for a Civic on my 80 for the boost and fuel pressure gauges.
Question: What gauges are you wanting to get? I personally can't think of any ofther gauges needed unless you have a turbo charger or a diesel.
I suppose you may want a tranny temp, and oil temp and...
They do look kind of cool...
About the only other on board gauges/information I would probably want would come from one of those ECU bluetooth thingy's and my (Galaxy S2) phone to tell me fuel mileage and other engine diagnostics.
From what I'm reading on this post, it sounds like you may have to fab up a close match. Slighlty un related, but on my last expo rig, a F350 4x4 Crewcab, I want a snorkel and there wasn't one made for it, but I found that a late 90's Range Rover Discovery had almost (and I mean reaaalll cloase) to the same angle A pillar and lines. So I bought one and bolted it on. Looked and worked great!
Moral of the story, if you can do some research, try to find a real close match and then cut to fit and paint to match as they say.
I suppose you may want a tranny temp, and oil temp and...
They do look kind of cool...
About the only other on board gauges/information I would probably want would come from one of those ECU bluetooth thingy's and my (Galaxy S2) phone to tell me fuel mileage and other engine diagnostics.
From what I'm reading on this post, it sounds like you may have to fab up a close match. Slighlty un related, but on my last expo rig, a F350 4x4 Crewcab, I want a snorkel and there wasn't one made for it, but I found that a late 90's Range Rover Discovery had almost (and I mean reaaalll cloase) to the same angle A pillar and lines. So I bought one and bolted it on. Looked and worked great!
Moral of the story, if you can do some research, try to find a real close match and then cut to fit and paint to match as they say.
Last edited:
- Thread starter
- #9
It's for the boost on my super charger. I bought a PLX 200 that has the ability for a bunch of different sensor readings and ODBII code viewing/resetting. I don't want to have my phone as the main source for that information since it gets used for Nav and calls while on the road. Has anyone previously posting actually tried any of the solutions?