Wanted 67 Fj40 dash piece

[Patrick mahoney]

Looking for a portion of a dash of complete dash that I can cut a piece out of to patch mine. This is a 67 Fj40 but I believe almost all years have same dash looks.

 

[tjhaga]

No not all years have the same dash look, yours is the early style and may be the last year for it. My 68 has a smooth dash. Why not get creative and tack in a backer plate and then use a thin layer of “bondo” to fill in the slight depression. If you use tiger hair fiberglass bondo” you may even be able to create the lower “raised” area

 

[Indygbd]

I think I have most of that. I believe mine it cut to the left of that area. Can you measure the piece? Just how long the cut out is.

 

[Patrick mahoney]

I think I have most of that. I believe mine it cut to the left of that area. Can you measure the piece? Just how long the cut out is.

Yes I will measure it. If it’s larger than my cut out that’s fine i can cut it to fit. It’s length is 7.25” and height is 2.125 minus the area where the hole cutout is.

 

[Indygbd]

My parts dash has been cut too. The side that has been cut has been folded over about an inch. As you can see its a bit short. Your call. If you want to try and make it work. How about 20.00 for my time to cut it out and cover shipping.

 

[INCINR8]

Ive got a 1971 rub with a good dash located in So cal.

 

[HelloKitty65]

@mikes 64 fj40

 

[mikes 64 fj40]

Yours would be the same as a '64 it has the ribs also I pm'd you so it is yours if you want it.