Wanted 3.70 third member set. Rear heater motor, trans hump, more

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

M

MIKKELSEN

Joined
Oct 10, 2016
Threads
99
Messages
858
Location
Alachua, FL
Location
United States
Matching set of 3.70 third members fj40

72 rear heater motor

4 speed trans hump cover

Prices shipped to 88012

That's it for now.

Thanks,
Tim
 
$250 for the set. You would have to check fastenal for shipping. They have 155k on them
 
@mdsims
 
The fastenal here doesn't ship like others do. Stupid IMO. Also I think swapping in FJ60 stuff may be more difficult/complicated than I want from what I read. Spline count is different. Is that correct?

MDSIMS how much for your diff shipped to 88012?

I just may be out of luck on all this. It may be cheaper for me to buy new ring and pinions for both and swap them in.
 
MIKKELSEN said:
The fastenal here doesn't ship like others do. Stupid IMO. Also I think swapping in FJ60 stuff may be more difficult/complicated than I want from what I read. Spline count is different. Is that correct?

MDSIMS how much for your diff shipped to 88012?

I just may be out of luck on all this. It may be cheaper for me to buy new ring and pinions for both and swap them in.
Click to expand...

FYI - I'm not trying to influence any sell you may have pending, but thought I'd throw this out there. It shouldn't be too difficult to use the 60's diffs, it is just getting the right pinion flange to match. These guys "Cruiser Outfitters" would have what you need to accommodate them. Note, when buying used 3rd's, I've been advised to at least replace the pinion seal. So a new pinion flange at the same time isn't too big of a hassle.

HTH
 
Last edited:
You must log in or register to reply here.

Share this page

Back
Top Bottom