200 series TTD Scangauge Auto temp Xgauge

[Jays200]

May want to try this.

Just released from Australian distributor

http://scangauge.com.au/wp-content/u...Toyota-ATF.pdf

August 16, 2011​

Automatic Transmission Temperature X-Gauge for Toyota Vehicles​

Below is an experimental code for Toyota vehicles. We have confirmed this works in the
Landcruiser 200 Series Diesel using v4.02+ SG2 firmware and we have unconfirmed reports
that this code will work on the 150 series Prado diesel and 120 series V6 petrol using a v4.02
firmware ScanGauge2.
We are unsure if this X-Gauge requires ‘v4.02 - onwards’ to work or if it will work on any XGauge
enabled ScanGauge2.

TXD: 07E121D9
RXF: 032100000000
RXD: 2808
MTH: 00010001FFD8​

NAM: TFT


Regards,

Jayson

 

[tempestv8]

We now have confirmation that ScanGauge II with firmware version 3.15 or 3.17 MB does not work with these new X-Gauges.

But there's hope for 4.02 and 4.05 owners. But for those with 3.xx. there is an "upgrade" available to 4.05 by way of a system board replacement.

I'm waiting for my ScanGauge to arrive and I'll test it out and report back.

 

[imerp]

Just installed scan gauge on 2008 with 90,000 miles
Programmed in transmission temp and with nothing towed.it read in range of 185-210 deg F
This seems high
I have a LC100 and transmission temp on that reads 136 to 158 over similar roads
Anyone else got a LC200 transmission temp

 

[Desert Nomad]

I get the same readings (79'c-96'c) this is with outside temp of 40-45'c. Goes mid to high 90,s when being pushed. Bottom left gauge is trans temp in 'c this was a 2 hour drive with cruise control the whole way and very flat roads.

 

[imerp]

Does anyone know if the transmission sensors for the 100 is in the same place as the 200 series??
This could explain the big difference between the two