Builds 1997 Lexus LX450 - Rexus the 500 HP LS SWAPPED LX450
- Thread starter bulhas
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #62
yup, i ordered the over 4" by accident.... just took it for a quick rip, feels better, but I think Ill have to trim these down by aorund .5-1" to get where they should be
I have been thinking about ordering a 6" slee lift lately though.... sooo I may run for a bit as is
I have been thinking about ordering a 6" slee lift lately though.... sooo I may run for a bit as is
- Thread starter
- #63
i took a couple better shots of the bumper install
- Thread starter
- #65
how do you like your new bumper??? had it held up to the wheeling you've been throwing at it??
- Thread starter
- #67
I'm a little concerned of the advertisement......
I might get a piece of 1/4 " steel and put in place to withstand a hit
- Thread starter
- #69
Well I upgraded to the sequoia 150 alternator with the photoman smaller pulley and bracket today
Fairly simple task but requires you to have some longer limbs and slightly smaller and than I have, all in all 2.5 out of 5 for difficulty
While I had the whole electrical apart, I wondered if my factory ground sucked, as my deck no longer worked well and the odd time I'd notice my lights weren't very bright, well what a difference some 1/0 makes
I was going to order a kit, but by the time I would have paid for it the Canadian price for me made making them a better deal plus you have a better appreciation for your own work
All in all wiring I think is a must, vehicle seems to have proper functioning electronics
Fairly simple task but requires you to have some longer limbs and slightly smaller and than I have, all in all 2.5 out of 5 for difficulty
While I had the whole electrical apart, I wondered if my factory ground sucked, as my deck no longer worked well and the odd time I'd notice my lights weren't very bright, well what a difference some 1/0 makes
I was going to order a kit, but by the time I would have paid for it the Canadian price for me made making them a better deal plus you have a better appreciation for your own work
All in all wiring I think is a must, vehicle seems to have proper functioning electronics
Last edited:
- Thread starter
- #70
Hers a quick picture
- Thread starter
- #71
well another major part ordered
I was hoping to honestly order shocks before a rear bumper BUT I couldn't really turn this bad boy down!! Its in stock and shipping to the border
I was hoping to honestly order shocks before a rear bumper BUT I couldn't really turn this bad boy down!! Its in stock and shipping to the border
- Thread starter
- #73
i just got lucky and sean huston had one left over 
- Thread starter
- #76
37's are on!!! Did some test flexing, doesnt seem like it will rub yet
Im sure Moab will prove me wrong!!!
- Thread starter
- #78
- Thread starter
- #79
